Klein Tools VDV526-052 Manuel d'utilisation et d'entretien Page 4

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 16
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 3
ESPAÑOL
6
7
The 1-2 pair pins are shorted
together and the 7-8 pair is
open. The pins with the errors
are flashing. Dash lines (-) on
the bottom (remote) display
line indicate the short, while
no numbers on the bottom
line indicate the open pair.
T568A Cable with a miswire and
unrecognized continuity:
Pins 1
and 2 on the
LAN Scout™ Jr.
are connected to pins 2 and 1 at
the remote-end. The pins with this
error are flashing. The “U” for the
remote pin numbers indicates an
unrecognizable continuity was
detected that is neither a short
or open.
WIRING AND DISPLAY EXAMPLES
Tester
Remote
Tester
Remote
T568A Cable with a Short and Open:
T568A Cable with a Miswire and
Unrecognized Continuity:
FLASHING
BATTERY REPLACEMENT
1. Remove
single screw in the middle of the back of the
LAN Scout™
Jr.
with a #0 Phillips head screwdriver. Remove battery door.
2. Recycle
exhausted batteries. Hitting the palm of your cupped
hand with the back of the
LAN Scout™ Jr.
will usually dislodge the
batteries from the compartment.
3. Acquire
4 x 1.5 alkaline batteries (IEC LR44, ANSI/NEDA 1166A).
4. Insert
batteries into battery compartment with the battery plus sign
(+) in the direction of the plus sign on the case (the spring contact is
negative and the button contact is positive). Inserting the last battery
in the middle of the stack is the easiest.
5. Replace
battery door and screw, taking care not to over-tighten it.
ESPAÑOL
ESPAÑOL
ESPAÑOL
ENGLISH
WARRANTY
www.kleintools.com/warranty
CLEANING
Turn instrument off and disconnect any cables. Clean the instrument by
using a damp cloth. Do not use abrasive cleaners or solvents.
STORAGE
Remove the batteries when instrument is not in use for a prolonged
period of time. Do not expose to high temperatures or humidity. After a
period of storage in extreme conditions exceeding the limits mentioned
in the Specifications section, allow the instrument to return to normal
operating conditions before using it.
DISPOSAL / RECYCLE
Do not place equipment and its accessories in
the trash. Items must be properly disposed of in
accordance with local regulations.
Prior to disposal of this product, please contact
Klein Tools for proper disposal options.
Vue de la page 3
1 2 3 4 5 6 7 8 9 ... 15 16

Commentaires sur ces manuels

Pas de commentaire