Klein-tools VDV501-814 Manuel d'utilisateur télécharger pdf (Page 10)

ENGLISH

T568A Cable with a Short and an Open:

The 1-2 pair pins are shorted together and the 7-8 pair is open. The pins

with the errors are flashing. Dash lines (-) on the bottom (remote) display line indicate the short, while no numbers

on the bottom line indicate the open pair.

T568A Cable with a miswire and unrecognized

continuity:

1 and 2 pins on the

VDV Scout™ Pro

are

connected to pins 2 and 1 at the remote-end. The pins with

this error are ﬂ ashing. The “U” for the remote pin numbers

indicates an unrecognizable continuity was detected that

is neither a short or open. An ID remote connected to the

VDV Scout™ Pro

when in cable test mode would also

show this error.

FLASHING

T568A Cable with a Miswire and

Unrecognized Continuity:

T568A Cable with a Short and Open:

Tester

Remote

Tester

Remote

T568A Cable with Split Pairs:

WIRING AND DISPLAY EXAMPLES

T568A Cable with Split Pairs:

A common error in building a cable is to put all the pairs in pin sequence 1-2, 3-4,

5-6 and 7-8. This will produce the correct continuity, but the pairs are designated to be on pins 3-6 and 4-5 in the

middle of the connector for compatibility with phone wiring. This wiring error is only detected by the split pair

test since the designated pairs are not twisted together.

Tester

Remote

Coax Cable Properly Wired:

Coax Cable Properly Wired with ID Remote #1:

The #1

ID remote is used to terminate a properly wired coax

cable. The video test passes, ID #1 is detected, and the

"o"s across the bottom of the screen show that the tester

is running tests continuously.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 35 36

Pas de commentaire

Klein-tools VDV501-814 Manuel d'utilisateur Page 10