Klein-tools VDV501-823 Manuel d'utilisateur télécharger pdf (Page 10)

ENGLISH

TESTING CONTINUITY & CABLE IDENTIFICATION SIMULTANEOUSLY – INSTALLED RJ45/RJ12 CABLE

Attach a numbered Test-n-Map™ ID Remote to the RJ45/RJ12 port

of each room that needs to be identified using a known

good patch cable

‡

. Write down the number of the remote and of the room number/description in which it is placed for

comparing/identifying the cables later.

Take the VDV Scout

Pro 2 to the distribution point

(often a wiring closet, switch or router at the other end of the cable

being tested).

Connect an unknown cable to the RJ45 port

on the top of the tester.

Press the data button

or phone button

on the keypad to begin the test on the Ethernet or phone cable, respectively. The

LCD will display “Data ID#” or “Voice ID#” where “#” is the ID number of the Test-n-Map™ ID Remote connected to the other

side of the cable.

Compare this number to the remote number/room pair list you made in step 1

and mark the cable with a piece of labeled

tape, print a label or mark with a permanent ink pen. The LCD will also display the results of the continuity test. These results

should be interpreted using the

Wiring and Display Examples

section.

Wiring and Display Examples

section.

Wiring and Display Examples

Repeat steps 4 and 5 for each unknown cable

until all have been labeled. You can use these labels to determine which rooms

should be connected to the cable splitter, or to troubleshoot intermittent connections in the future.

‡

Note:

Only Klein Tools Universal RJ12 Jumper Cable (VDV726-125) or an approved equivalent should be used in the RJ45 jack of the

Test-n-Map™ ID Remotes. Using a standard RJ11/12 patch cable could result in damaged contact pins.

TESTING CONTINUITY & CABLE IDENTIFICATION SIMULTANEOUSLY – OVERVIEW

The VDV Scout

Pro 2 has the capability of simultaneously testing continuity and providing cable location identification for up to eight

locations with Test-n-Map™ ID Remotes (included in some kits, or sold separately). The VDV Scout

Pro 2 series testers come with

either the standard self-storing remote #1 or the Self-Storing Test-n-Map™ ID Remote #1. Test-n-Map™ ID Remotes #2 through #8

are included in some kits, or sold separately in the VDV Scout

Pro 2 Test-n-Map™ ID Remote Kit (VDV770-827).

VDV Scout

Pro 2 Test-n-Map™ ID Remote Kit (VDV770-827)

1 2 ... 5 6 7 8 9 10 11 12 13 14

Commentaires sur ces manuels

Pas de commentaire

Klein-tools VDV501-823 Manuel d'utilisateur Page 10

Commentaires sur ces manuels

Produits connexes et manuels pour Instruments de mesure Klein-tools VDV501-823